Idiomas disponibles
Idiomas disponibles
INTRODUCTION
RUNPOTEC appreciates your purchase of a RC2 inspection-camera. These
instructions for use provide information on safe use of your RC2 inspection-
camera. Read the instructions for use thoroughly before commissioning.
If you have any questions about commissioning, assembly, safety and
applications, or problems, please contact your dealer or RUNPOTEC by
telephone or e-mail. You will find our contact data on page 2.
SAFETY INFORMATION
Read the safety information on www.runpotec.com before use. The
RC2 inspection-camera is used exclusively for the exploration and
inspection of inaccessible components such as pipelines, hollow
systems, ventilation systems, etc. No liability is accepted for any
other use! No liability is accepted for any other use!
COMMISSIONING
Insert the Micro Memory
Card into the slot at the
side. If necessary, format
the card, see operating
instructions.
COMMISSIONING - LED-LAMPE
+
Remove insulation strip
2
Thread
close completely
INSTRUCTIONS FOR USE
General
Photo/video
mode
RUNPOTEC GmbH – Irlachstrasse 31 – A-5303 Thalgau
Tel.: +43-6235-20 335 – Fax: DW 35 – [email protected]
1
Camera head cable
connect with monitor.
2
Battery
Press and hold for 1,5 seconds to switch on and off
Rotate monitor image 180°.
Switch camera LED light on and off.
Adjust monitor brightness in 3 levels.
Press and hold for 3 seconds to switch to Capture mode or
to switch between Photo/Video mode.
Display top: Mode Photo/Video icon, battery status, memory
card, date, time.
Briefl y press to switch to the corresponding mode, take a
photo or start and stop video recording (recording time is
displayed in the upper right-hand corner). File is stored in the
archive.
2
The Li-Ion battery is charged!
Monitor can be used imme-
diately. Charge the battery
with the USB-C charging
cable and charging adapter.
Charging socket - USB-C
Switch on/off: via thread
ENGLISH
13
3
1
O-ring
1
