Venmar ESB10 Instrucciones De Instalación página 3

ABOUT THIS MANUAL
Please take note this manual uses the following symbols to emphasize particular information:
ZN WARNING
Identifies an instruction which, if not followed, might cause serious personal injuries including possibility of death.
a an instruction which, if not followed, may severely damage the unit and/or its components. |
NOTE: Indicates supplementary information needed to fully complete an instruction.
NOTE: Because this publication covers many hood models, the illustrations are typical ones. Some details of your unit may be
slightly different of the ones shown.
TOOLS NEEDED TO INSTALL THE RANGE HOOD
- Phillips screwdriver no. 2 or Robertson no. 1 and no. 2
- Pair of long nose pliers (to open the horizontal or vertical discharge knockout hole)
- Hammer and flat blade screwdriver (to open the electrical knockout hole)
- Sheet metal sheers
- Pair of pliers
- Scissors (to cut duct tape)
- Pen
- Wire stripper
TABLE OF CONTENTS
1. INSTALL DUCTWORK 0 ee eee eee eee 4
2. MEASURE THE INSTALLATION 2000 ee eee nets 4
3. PREPARE THE INSTALLATION 2.000 eee een eee eee ene 5
4, PREPARE THE HOOD 2... eee nee e nee 5-6
5. INSTALL THE ADAPTER/DAMPER .. 0.0. eee eee eee nee 6-7
6. INSTALL THE HOOD 6 en nee nnn ees 7
7. CONNECT WIRING 0000 ee eee ene eee e eee 7
8. REINSTALL BOTTOM PANEL AND FILTERS 2.0000 ee eee eee eee ene 8
9. FLUORESCENT LAMPS 2000 nn nee ne ee ee eee 8
10. CLEANING 20 ee eee eee eee 9
11. OPERATION £00 ee ee nee eee eee 10
12. SERVICE PARTS 00 eee eee e eee eens 11-12