Broan EVOLUTION 2 QP2 Serie Instrucciones página 3

BR N
QP2 SERIES
Stainless Steel Cleaning
DO:
• Regularly wash with clean cloth or rag soaked with warm water
and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after cleaning.
Wipe dry completely.
• You may also use a specialized household stainless steel cleaner.
DON'T:
• Use any steel or stainless steel wool or any other scrapers to re-
move stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach the
hood. During construction/renovation, cover the range hood to
make sure no dust sticks to the stainless steel surface.
Avoid: When choosing a detergent
• Any cleaners that contain bleach will attack stainless steel
• Any products containing chloride, fluoride, iodide, bromide
will deteriorate surfaces rapidly.
• Any combustible products used for cleaning, such as ac-
etone, alcohol, ether, benzol, etc. are highly explosive and
should never be used close to a range.
Page 3
LAMP SOCKET
BRACKET
LIGHT
PANEL SCREWS
To change the depth of bulb sockets:
- Remove bottom pan (See Step 10).
- Remove 2 Ljght Panel Screws and _ Panel. Set
screws aside.
- Loosen 2 Screws holding Lamp Socket Bracket to
Panel.
- Adjust socket/bracket to desired depth.
- Re-tighten screws securely.
- Re-attach light panel and bottom pan.
INSTALL THE DUCTWORK
LIGHT BULB REPLACEMENT
(Ducted Hoods Only)
SUCTION
CU P TOOL
(1)
LIGHT PANEL
-_REWS
LIGHT PANEL
CAUTION: Bulbs may be hot. Always allow bulbs
to cool down before removing them.
This hood uses (4)_en Bulbs (included with hood). Use 120
V, 50W, shielded halogen bulbs - MR16 with GU10 base.
NOTE: Suction Cup Tool (included with hood) can be used to
install and remove light bulbs.
Align pins on bulb with large diameter opening on socket, then
push bulb in towards hood and rotate clockwise until firmly seated.
The position of the bulb socket (depth) is adjustable and may
require adjustment when:
a) certain brands of bulbs are difficult to install.
b) the bulb protrudes too far below the light panel.
ROOF CAP
3¼" X 10" or
7" ROUND DUCT
(For vertical
HOUSE WIRING
or Back of hood)
WALL CAP
t
24"- 30" ABOVE 3¼"X 10" DUCT
COOKING SURFACE
(For horizontal discharge)
53
Determine whether hood will discharge vertically (3W' x
10" or 7" Round), or horizontally (3W' x 10" only).
Decide where the ductwork will run between the hood
and the outside.
Choose a straight, short duct run to allow the hood to
perform most efficiently. Long duct runs, elbows and
transitions will reduce the performance of the hood. Use
as few of them as possible. Larger ductwork may be
required for best performance with longer duct runs.
El Install wall roof Connect metal ductwork to
cap
or
cap.
cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.