GE AEM25 Serie Manual Del Propietario Y Instrucciones De Instalación página 9

Installation Instructions
D WINDOW REQUIREMENTS
•These instructions are for a standard double-hung
window. You will need to modify them for other types
of windows.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within reach of the
power cord.
• Follow the dimensions in the table and illustration
for your model.
19 1/4;'
= 29" - 41 "
(With accordion panels)
1
I
[] STORMWINDOW REQUIREMENTS
A storm window frame will not allow the air
conditioner to tilt toward the outside, and will keep it
from draining properly.
To adjust for this, attach a piece of wood to the sill.
WOOD PIECES
WIDTH:2"
LENGTH:Long enough to fit inside the window
frame.
THICKNESS: To determine the thickness, place a
piece of wood on the sill to make it 1/2" higher
than the top of the storm window frame or the vinyl
frame.
Attach securely with nails or screws provided by the
installer.
1/2" higher
than storm
window
frame
Storm window
frame
1/2" higher
than
vinyl
frame
_ _(°ns°mewind°ws v/Woo d
- r'- Vinyl frame I I
D PREPARETHE AIR CONDITIONER
[] Pull down the front panel and remove the filter.
Remove the front panel by lifting up at an
angle.
r-_ Remove the four front screws. Save them
for reinstalling the front housing.
[] Grasp the lower corners of the grille while
pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the bottom edge
toward you more than 3" or you may
damage the tabs of the grille.
e
@
When the front grille is removed the
control panel will still be attached by
a harness. Turn the grille around so
you can see the back side of the grille.
Remove the 2 screws to separate the
control panel housing from the grille.
NOTE: Be sure to save these screws. You will
need them later in the installation.
Remove Screws
9