Jatrhg EV PowerBox Manual De Instrucciones página 2

For the first use, turn the button to the right to exit the emergency stop mode:
Installation Steps of EV Charging Station on the Wall (G, H, I, A )/ Pedestal stand
1. The H back panel has already
2. Put the backplane I on flat wall and
been secured with four screws
mark the positions of four screw
to the back of the control box
holes.
of the electric vehicle charger
Make sure not to invert I
4.Use a hammer to knock the
5. Pass four long screws in bag
plastic anchor in bag A into the
A through backplane I holes to
drilled holes vertically, until its
the anchors in the wall, and
surface flush with the wall.
turn them tightly.
7. Use A2 to fix the two back panels: H/I.
Installation Steps of Cable Holder (F, B1, B2)
3.Use Φ6mm drill bit to drill holes
at the marked position, hole depth
about 40mm.
6. Insert the charging pile G from
top to bottom into the back panel
I fixed on the wall, ensuring that all
four slots are fully inserted.
1. Put the bottom base of this 2. Use Φ6mm drill bit to drill holes
holder F on the flat wall, and at the marked position, hole
mark the positions of three depth about 40mm.
screw holes.
4. Use three long screws in bag 5. Use a screwdriver to tighten the
B1 to pass through bottom screws so that the base does not
base holes and insert into the loosen or tilt.
anchors.
3. Use a hammer to knock the
plastic anchor in bag B1 into the
drilled holes vertically, until its
surface flush with the wall.
6. Align the upper cover with the
base and press its edges to lock,
then screw two short screws in
bag B2 to ensure fixed tightly.