Idiomas disponibles
Idiomas disponibles
EN
UNIFIX – PANEL FIXING
• Clean each mounting stud: dust with a slightly damp cloth
• Wait until the surface is dry.
• Apply the preparation degreaser with another cloth.
• Install the low wedge and then the blocking wedge on all four corners.
•
Fix the 4 brackets on your panel
•
Clean the bottom of the brackets (area that will get glued) with the degreaser provided (do
not use alcohol/white spirit...). Follow the same operation on your 4 mounting brackets. Apply
the same method to clean the surface of support.
This step is mandatory and must be respected in order to guarantee a good
adhesion of the sealant on the mounting brackets and the mounting area.
Your bonding surfaces (installation area and mounting brackets) must be clean,
dry, grease-free and dust-free.
Clean the surfaces beforehand with a damp cloth (not supplied), then leave to dry
for a few minutes. (do not use alcohol / white spirit).
The use of the degreaser-preparer is mandatory.
www.uniteck.fr
Then
10
