LEGRAND C2G C2G31017 Manual Del Usuario página 7

HDMI HDBaseT + VGA , 3.5mm, RS232, and IR over Cat Extender Dual Gang
Wall Plate Transmitter - 4K 60Hz
Operation
Input Select Button and Switching
This transmitter will select an active input or the first-come first-served if both inputs are active.
•
The input select button can select either input source only if both inputs are active.
•
Key function description:
1. If HDMI IN and VGA IN are both connected to the source devices, and HDMI IN is selected as current source, pressing the input select button
will switch to VGA as source. If the VGA source is unplugged, it will switch back to HDMI IN automatically.
2. If only HDMI IN is connected to the source device, and HDMI IN is selected as current source, pressing the input select button will have no
effect and it will remain as HDMI IN.
EDID Management
The transmitter equips a 3-pin DIP switch on front panel for EDID configuration of VGA input.
1
0
By default, the EDID switch is set in "010" position. To configure EDID for VGA input, refer to
the following table:
Note:
The EDID configuration changes of VGA input will take
•
effect immediately.
HDMI input EDID is copied from HDBaseT receiver.
•
5
(us) (us)
(us)