Costway NP10572 Manual Del Usuario página 3

EN
ASSEMBLY INSTRUCTIONS
1. Choose a location which will receive as much as possible sunlight for
your solar shower.
2. Mount the lower stand with shower base (B) to concrete slab or wood
base with four bolts, washers and nuts (G). We recommend to use
wrench.
3. Attach shower head (D) with the gasket (E) into the thread of the
upper stand (A). Adjust this parts only with your hands. Do not use a
wrench.
4. Put the O-ring (C) into the lower stand (B).
5. Connect the upper stand(A) with the lower stand(B). Connect the
hoses.
6. Turn the locking ring clockwise to connect the two stands (A+B).
Handle and shower head (D) need to face the same direction.
7. Attach faucet (I) with gasket (E) to the lower stand (B).
INITIAL SET UP OF THE SOLAR SHOWER
1. Open the handle and turn it to position "hot". This ensures that no air
pockets are trapped in the hoses while filling with water.
2. Attach your garden hose to the hose connector (F1 General standard
or F2 US standard) .Turn on the water to fill the solar shower. It will take
some minutes to fill up the solar shower.
3. When the water flows out of the shower head (D) turn the handle off.
Now the solar shower begins to heat the water.
4. Depending on available sunlight and outside temperature, the solar
shower will take about two hours to fully heat the water.
5. Water temperature in the solar shower can reach up to 60
strong sunshine.
WARNING：To avoid scald, pay attention to turn the handle to "cold"
water position before using the solar shower. Then adjust the desired
temperature.
04
WINTERIZATION
1.Turn off and disconnect the garden hose.
2.Open the handle and turn it to position "hot" to allow the water to drain
out of the hoses and solar shower (This takes approximately 8-10
minutes). Do not turn off or turn the handle while draining, otherwise the
water will stop draining out.
3.Turn the locking ring counter- clockwise to unthread the upper stand
(A) from the lower stand (B). After this, please disconnect the hose
connection. Now the water can run out of the solar shower.
4.Disassemble the lower stand (B) and drain the remaining water out of
the solar shower.
5.Clean and dry all solar shower parts.
6.Store all solar shower parts indoors and in a dry place during winter
season to prevent frostbite.
ATTENTION
-Do not use salt or other anti freezing methods.
-Recommended water pressure: maximum 3.5 bars. Without any
circumstances should the solar shower be operated by an additional pump
or domestic water supply.
-The heating of the water results an expansion of the water. This allows
the water to escape minimally out of the shower head.
-When initially using the shower and in order to get rid of plastic and oil
smell, please let water run out for several minutes and clean the shower
inner parts with flowing water.
C during
O
EN
05