J
2
OR
J
1
M10x25
J
1
Φ12/40
J
2
02
EN
ASSEMBLY INSTRUCTIONS
1. Choose a location which will receive as much as possible sunlight
for your solar shower.
2. Mount the lower stand with shower base(B) to concrete slab or
wood base with four bolts, washers and nuts (K). We recommend to
use wrench.
3. Attach shower head (D) with gasket (G) to the extension pipe (E).
Attach the extension pipe (E) with gasket (F) into the thread of the
upper stand (A). Adjust this parts only with your hands. Do not use a
wrench.
4. Put the O-ring (C) onto the lower stand (B).
5. Lift the upper stand (A) onto the lower stand (B). Connect the
hoses.
6. Turn the locking ring clockwise to connect the two stands (A+B).
Handle and shower head (D) need to face the same direction.
3
INITIAL SET UP OF THE SOLAR SHOWER
1. Open the handle and turn it to position "hot". This ensures that no
air pockets are trapped in the hoses while filling with water.
2. Attach your garden hose to the hose connector (J1 General standard
or J2 US standard).Turn on the water to fill the solar shower. It will
take some minutes to fill up the solar shower.
3. When the water flows out of the shower head (D), turn the handle
2x
off. Now the solar shower begins to heat the water.
4. Depending on available sunlight and outside temperature, the solar
shower will take about two hours to fully heat the water.
5. Water temperature in the solar shower can reach up to 60
during strong sunshine.
WARNING: To avoid scald, pay attention to turning the handle to
"cold" water position before using the solar shower. Then adjust the
desired temperature.
(140 )
03
