Instructions For The User; Starting The Machine - Isomac RELAX Manual De Uso Y Mantenimiento

! do not fill the tank with water when the machine is plugged in
! make sure there is water in the tank when the machine is operating
! never place your hands or other parts of the body in the path of the water/steam nozzle. Hot water
and steam can cause serious burns
! never place your hands or other parts of the body or any other object inside the machine when it is
plugged in
! never touch the machine with wet hands or feet
! never touch the hot parts of the machine (bottom of coffee distributor and water/steam nozzles)
! before performing any routine maintenance make sure the machine is unplugged, without pulling
the power cable, or that the main circuit breaker is off
! if the power cable should be damaged and have to be replaced, order a new cable from the
manufacturer and/or its service center
! never immerse the coffee machine in any type of liquid
! do not use detergents or abrasive substances to clean the machine
! do not leave the machine exposed to atmospheric agents
! do not leave the machine within reach of children or people who are not capable of using it
! keep the coffee maker away from any heat sources

4. INSTRUCTIONS FOR THE USER

4.1 Starting the machine

RELAX/TEA
To start the
• open the external packing and take the machine out. Inspect the machine to ascertain that it is
intact and in good condition. Check for the presence of all the accessories supplied with the
machine (see paragraph 1.1)
• position the machine on a flat surface
• remove the cover and take out the water tank (located inside the machine) and rinse it
• fill the container with clean water, return it to its housing and insert the silicon tubes. Close the
cover on the machine
• plug in the machine
• switch the machine on with the main switch (1). The power ON light (2) and heating element
light (13) will be lit
Perform the following operations every time you switch the machine on and every time you draw
steam:
• press/push up the coffee switch/lever (7). Water will come out of the bottom of the coffee
distribution unit (3)
• press/lower the coffee switch/lever again (7). The boiler will automatically fill with water
• wait about 3-4 minutes for the machine to be pressurized. The heating element light (13) goes
off and the coffee light (12) goes on
RELAX/TEA
At this point the
If the water in the tank is used up, a micro switch located under the tank plate will switch the machine
off automatically.
To start the machine again proceed as follows:
• switch off the machine with the main circuit breaker (1)
• unplug it
• fill the tank with water
• plug in the power cable
espresso coffee maker, follow the instructions below:
coffee machine is ready for use.
13