Courtyard Creations TGS64SD Instrucciones De Armado

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS64SD-CS05-1
2
TGS64SD-CS04-1
TGS64SD-CS04-2
3
4
62TGS64SDY101
5
17C17A0403001Y4
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #10)
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) and the supports (#3) into the plastic
holders attached on the underside of the table top (#1)
rim. Fasten them together by using screws (#5).
See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
!
Do not sit or stand on this table.
!
A weighted umbrella base must be used when using an umbrella with this table.
!
Do not discard of any of the packaging until you have checked that you have all of the parts
!
and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed
!
by children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
V-4
INTENDED FOR RESIDENTIAL USE ONLY.
TGS64SD
PART Q'TY
1
TABLE TOP
4
LEG
2
SUPPORT
1
CENTER
CONNECTOR WITH RING
6
SCREW ST4.2*12
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DO NOT RETURN TO THE STORE!
STOP
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
17C01A0706002Y4
6
7
17C01A0709002Y4
8
17FA05040301-Y4
9 18000337002
10
17KAA0201----Y4
FIGURE 1
2
2
3
1
COURTYARD CREATIONS INC.
PART
BOLT M6*16
BOLT M6*25
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX. KEY WRENCH 6MM
2
2
3
Q'TY
8
2
10
10
1
5