Idiomas disponibles
Idiomas disponibles
INSTALLING THE LIGHT KIT AND GLASS SHADE
Adapter
plate
Fig. 1
NOTE: Before starting installation, disconnect the power by
turning off the circuit breaker or removing the fuse at fuse
box. Turning power off using the fan switch is not sufficient
to prevent electric shock.
If you do not wish to install the light kit, skip this
step and proceed to next step.
1
Remove one of the three screws on the mounting hub
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Place the key holes on the adapter plate over the 2 screws
2
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.
Remove one of the three screws on the adapter plate
3
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 2)
Mounting hub
(bottom of motor)
Glass shade
Screws
Fig. 2
4
While holding the LED light kit under your fan, make the
polarized plug connections: (Fig. 2)
- White to white
- Black to blue
Tuck connections neatly into adapter plate. Place the key
5
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
5
loosened and the one previously removed.
6
Raise the glass shade or metal cover against the LED light kit
and turn clockwise until snug, DO NOT OVERTIGHTEN.
7
Restore power and your light kit is ready for operation.
Wire connectors
Light kit
©2023 Hinkley Lighting, Inc. | hinkley.com |
Adapter plate
Screws
11
