Idiomas disponibles
Idiomas disponibles
PART LIST
Gate Frame
4 x Adjustable Wheels (already
assembled to the Pressure Bolts)
ASSEMBLY INSTRUCTION
NOTE: There is a gap between the
latch and frame when you receive
the gate. This is NORMAL because
this gate is installed by reaction
force. So the gap will disappear after
installation is finished. The Gap is
NOT a Defect! If you cut the belt
accidentally before installation,
please re-tie the latch with a
rope/belt as shown in figure to
ensure the door can lock normally
after installation.
04
4 x Pressure Bolts
1 x Wrench
Step 1
Rotate the wheel of pressure bolts to the top. (To prevent stuck, leave a
little gap between the top and the wheel.)
Step 2
Install the 4 pressure bolts as shown
in Diagram B1.
THE ENDS OF THE GATE FRAME
ARE NOT THREADED. THE
PRESSURE BOLTS WOULD SLIDE
INTO THE END OF FRAME TUBES
WITHOUT RESISTANCE.
Push the pressure bolts into the frame
tube until the bolts' wheel hits the end
of the frame tube as shown in
Diagram B2.
Adjustable wheel
Diagram B2
Diagram A
Diagram B1
End of the frame tube
05
