FAFREES F20 Light Manual Del Usuario página 6

Function introduction:
1.Charging: Find the charging port on the left side frame of the battery, connect the
charger to charge. When the battery is fully charged, the charger light changes from red to
green.
2.Power On/Off: Long press the power button to turn on/off the display power.
3. Display: After the display is turned on, the display will show the real-time speed (km/h)
and the trip distance(km) by default. By pressing the power button, the information
displayed will be switched between the trip distance (km), ODO (km), maximum speed
(km/h) and average speed (km/h).
4. Headlight: By pressing and holding the plus button, the controller will turn on/off the
headlight.
5. PAS Mode: You must turn on the battery to use the e-bike in pedal-assisted mode.
Power assist is triggered when you pedal forward, and stops when you stop pedaling,
sometime with a delay. If no power is needed, turn off the power of the battery
6. Electric Mode: You do not need to pedal the e-bike if you use the hand throttle. The
throttle can be controlled by twisting it from the resting position, and the farther the throttle
switch is from resting position, the more power is sent to the motor to accelerate the
e-bike.
7. Cruise Control : Cruise control will be triggered when you holding thumb throttle and
riding at the same speed for 8 seconds, and it will be released by braking/pedaling or
throttling.
8. Walk Assist Mode: Long press the "-" button, the electric bicycle will enter the walk
assist mode. The electrical bike runs at a constant speed of 6 km/h. The display will show
level P. Release the "-" button, the electric bicycle will immediately stop power output and
return to the state before walk assist.
3