Idiomas disponibles
Idiomas disponibles
CAUTION: Keep the cord away from
cutting area to prevent it from
becoming
work-piece.
Do not force the cut. Let the saw do the cutting at
the rate of speed permitted by the type of cut and
work-piece.
8.4.
CUTTING GUIDE
Guide clearance adjustor
Guide rails are available to assist in
making precise straight cuts and
enhance safety. (These are an
optional accessory) The guide rail
may be secured with C-clamps if
desired.
clearance adjustors for optimum fit and safety.
Adjust these equally so that there is no looseness,
yet the base still slides freely.
The rubber sighting strip:
The sighting / anti-splinter strip must be cut to size
along its full length before the first use. The rubber
strip must be backed by a work-piece when it is cut
for the first time.
CAUTION: Failure to use a backing work-piece on
the first cut may result in the rubber strip being
torn or damaged by the blade
Once it is cut to size, it will perfectly correspond
to the cutting edge and will also help to protect
the material from splintering. Once it is sized, the
operator can know at a glance exactly where the
line of cut will be. This saves a lot of time and effort
in making precise cuts.
9. MAINTENANCE AND REPAIR
9.1.
KEEP TOOL CLEAN
Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to
clean plastic parts. They could possibly dissolve or
otherwise damage the material.
Wear safety glasses while using compressed air.
Clean all parts of the lower blade guard mechanism
to ensure smooth operation.
14
entangled
in
the
There
are
2
guide
SUPER HAND DRY CUTTER 8320
9.2.
REPLACEMENT OF CARBON BRUSHES
The carbon brushes are a normal
wearing par t and must be
replaced when they reach their
wear limit.
To replace:
Kohlebürstenhalter
Remove the brush caps and
withdraw the old brushes. Replace
with new brushes (always replace
as a pair) ensuring that they align
properly and slide freely. Instal-
lation is the reverse of removal.
Then replace the brush caps.
CAUTION: Always replace the brushes
as a pair.
9.3.
STANDARD ACCESSORIES
• Carbide tipped saw blade 320x84T
• 5 mm L-hex key
If the replacement of the power supply
cord is necessary, this has to be done by
the
manufacturer or their agent in
order to avoid a safety hazard
