Idiomas disponibles
Idiomas disponibles
2. Usage safety
ATTENTION!
Read all safety warnings and all instructions. Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Dry Heat Sterilizer
2.1.
Electrical safety
a)
The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching sockets reduces the
risk of electric shock.
b)
Do not touch the device with wet or damp hands.
c)
Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a socket. Keep the
cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled cables increase the risk of electric
shock.
d)
If using the device in a damp environment cannot be avoided, a residual current device (RCD) should be applied. The use
of an RCD reduces the risk of electric shock.
e)
Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power cord should be
replaced by a qualified electrician or the manufacturer's service centre.
f)
To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use the device on wet
surfaces.
g)
ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other liquids.
2.2.
Safety in the workplace
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents. Try to think ahead,
observe what is going on and use common sense when working with the device.
b) If there are any doubts as to the correct operation of the device, contact the manufacturer's support service.
c)
Only the manufacturer's service point may repair the device. Do not attempt any repairs independently!
d) In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one intended for use on live electrical devices) to
put it out.
e) Please keep this manual available for future reference. If this device is passed on to a third party, the manual must be
passed on with it.
f)
Keep packaging elements and small assembly parts in a place not available to children.
g) Keep the device away from children and animals.
Remember! When using the device, protect children and other bystanders.
2.3.
Personal safety
a)
Do not use the device when tired, ill or under the influence of alcohol, narcotics or medication which can significantly
impair the ability to operate the device
b)
The device is not designed to be handled by persons (including children) with limited mental and sensory functions or
persons lacking relevant experience and/or knowledge unless they are supervised by a person responsible for their
safety or they have received instruction on how to operate the device.
c)
The device can be handled only by physically fit persons who are capable of handling it, properly trained, familiar with
this manual and trained within the scope of occupational health and safety.
d)
When working with the device, use common sense and stay alert. Temporary loss of concentration while using the
device may lead to serious injuries.
e)
Use personal protective equipment as required for working with the device, specified in section 1 (Legend). The use of
correct and approved personal protective equipment reduces the risk of injury.
f)
To prevent the device from accidentally switching on, make sure the switch is on the OFF position before connecting to a
power source.
g)
The device is not a toy. Children must be supervised to ensure that they do not play with the device.
2.4.
Safe device use
a)
Do not overload the device. Use the appropriate tools for the given task. A correctly-selected device will perform the
task for which it was designed better and in a safer manner.
b)
Make sure the plug is disconnected from the socket before attempting any adjustments, accessory replacements or
before putting the device aside. Such precautions will reduce the risk of accidentally activating the device.
c)
Disconnect the device from the power supply before commencement of adjustment, cleaning and maintenance. Such a
preventive measure reduces the risk of accidental activation.
