Idiomas disponibles
Idiomas disponibles
AC830 working as receiver function and LED instruction
•
AC830 is through toggle switch to select the mode is
transmitter or receiver mode after powered on. In power off
status, switch to "RX" end, and long press "multi-function key"
to power on,all paired device information will be cleared in TX
mode after powered on!!!Please don't switch TX/RX mode
within 3 seconds after powered off,because the chipset has
not been fully powered down,other wise it will enter into the
previous power off mode to re-turn on.
AC830 worked as Bluetooth Receiver can store 8 paired
devices record , the latest paired records will be replaced by
new paired records.(but the re-connection time will increase
for more Stored paired device. AC830 automatically
re-connection time: 7 seconds for the unit has 1 paired record,
12 sec. for the unit has 2 paired records,17 sec. for the unit
has 3 paired records, 22 sec. for the unit has 4 paired records)
1. Power on: In off state, long press MFB around 3 seconds,
after Blue LED flashes twice, AC830 is powered on. (If AC830
did not connect with any device, it could directly enter into
pairing mode automatically after power on)
2. Power off: In on state, long press MFB around 3 seconds,
Red LED flashes twice ( if release after Red LED on immedia-
tely, Red LED may only flashes once), AC830 is powered off.
Please don't re-power on the unit immediately in 3 sec. after
power off the unit, because the voltage of the chipset may not
disappear totally.
3. Pairing mode: Power on the unit, double click the MFB, Blue
& Red LED flashes alternately, the unit enter into pairing mode,
it will power off automatically if no connections in 5 minutes.
06 I
4. Play /pause: In music playing, short press MFB to pause,
press again to play continually
5. Clear up the pairing list: Power off with the current
working mode, 3 seconds later, change to the other working
mode, then power on, the pairing information for the former
mode will be cleared up
6. Re-Connect with all the connected device: Power on the
unit, AC830 will connect to all the connected device
automatically, but it only support two connections
simultaneously, prioritize the latest two connected devices,
after two connections successful, AC830 will be Blue LED light
on. (working as Bluetooth receiver, it only could receive audio
from the first working device ,If you want to receive signal
from the other device, the first working device must have to be
pause or turn off . (Bluetooth receiver two in one function).
7. Automatic power off: When the battery voltage is below
3.1V will automatically shut down, It will automatically power
off if there is no connection under non-matching record after
5 minutes. If the product has a matching record, it will
automatically power off if there is no connection more than
about 6 minutes, it takes about 1 minute to re-connect.
8. Pairing status: Blue and red Led light flash alternately used
as bluetooth receiver status.
9. No connection standby status: Blue Led light flash twice
every two seconds in no connection standby status
10. Connected standby status: Blue Led long light in
connected standby status
11. Low battery status: Low battery status (RX):red LED
flashes once every one second,and it will cover other Led light
(Charging immediately or power off will remove this status).
I 07
