Idiomas disponibles
Idiomas disponibles
The installation must be done by qualified technician according with the legal European
Standards.
Before any electrical manipulation, cut the electrical current.
Before the installation check if the selected installation place fulfils the security distances which appears at
the CEI standards. (fig-0)
If the plug cord is damaged, it must not be substituted, and the hair dryer must be throwing out.
When the hair dryer is used in a bathroom, unplug after use because the proximity of water
presents a risk, even when the hair dryer is switch off.
The device must be installed considering that, when the movable part is fully extended, it is beyond the
scope of a person which is taking a bath or a shower.
As additional protection, we recommend the installation of a residual current device (differential switch)
with a current default of operation not exceeding 30mA in the electrical circuit which supplies the
bathroom.
INSTALLATION:
To install the hair dryer, remove the screw as shown in Figure 1. Separate the ring to the base (Figure 2). Mark
the position of the holes using the base of the hair dryer and make it through a 6 mm drill. Insert thee dowels into the
holes, place the base in right position and screw the screws supplied (Figure 3). Re-assemble the ring on the base
(Figure 4) and screw on again the screw removed at the beginning of the installation (Figure 1).
From that moment, the hair dryer can stay in the ring provided for that purpose and is ready for use.
USE:
Place the light switch at the base (Figure 5) in position 'ON', a LED located on top of this switch becomes red.
Remove the hair dryer of its ring and choose the desired temperature using the switch located on the front of the gun.
You can choose between three positions: 'C' minimum flow and cold air,'1' minimum flow and hot air and '2' maximum
flow rate and temperature (Fig.-6). To switch on the hair dryer, keep pressing the switch located on the rear of the gun.
Releasing the button, the hair dryer stops automatically (Figure 7). The hair dryer base has two sockets, a European
type 230V and an 110V American type. Both plugs are only suitable for shavers and could not be used simultaneously.
In any case, these sockets are operatives when the switch shown in Figure 5 is in position 'ON'.
MAINTENANCE:
The hair dryer doesn't need any special maintenance. Take care and do not use aggressive products which
could damage the plastic. In any case, to use a wet rag without any other product is recommended. If the hair dyer is
damaged or has a problem, please call to an authorized technical assistance service to avoid danger situations.
This device have 2 years of total guarantee against whatever manufacturing problem or damage, both damaged spare
parts and labour cost will be included in this guarantee period. The validity of the guarantee starts from the purchasing
date, certified by the seller's stamp, and expires at the end of the indicated period, even when the device has not been
used. The guarantee has no validity when damages are caused by a incorrect operation, bad installation or not
according with the legal rules, or are caused by people unauthorised by the manufacturer.
Brand name : __________________________________________________________________________________
Model : _______________________________________________________________________________________
Serial nº : _____________________________________________________________________________________
Dealer's signature and stamp
INSTALLATION MANUAL
¡ATENTTION!
USER'S MANUAL
WARRANTY
FECHA/DATE: ___/___/______
