Victor Cosmopolitan Manual De Operación página 10

2) Press the CD eject switch, to open the disk tray door.
3) Place the CD face up, making sure it is fully placed.
4) Press the CD eject switch again to close the disk tray door.
5) To play a different piece on the record, Press the skip up
select the desired piece.
6) To adjust the volume level, turn the volume knob to the right or left.
Listening to the Radio
1) Tap the POWER/VOLUME knob to turn the equipment on.
2) Use the function selector to select TUNER mode.
3) Use the radio band selector to select the desired band (AM, FM).
4) Turn the tuning knob left or right to find the radio station.
5) Repeat the above step until your desired radio station is found.
6) Adjust the volume knob to your desired volume level.
7) AM reception: the receiver has a built-in AM bar antenna. If reception is weak, slightly rotate
or reposition the unit to improve AM reception.
8) FM reception: the receiver has a built-in FM wire antenna hanging at the rear cabinet. For
best reception, completely unravel and extend this wire.
9) FM-Stereo: receiving stereo programs. Once a stereo signal is received, the ST icon will light
up on the display.
10) When you have finished listening to the radio, tap the POWER/VOLUME knob to switch the
unit off. Unplug it from the power supply if you are not going to use it for a while
11) Press the play button
stations.
12) To play a stored radio station, press the skip up
radio station program you want.
13) Press the up and down button continuously for 3 seconds to search up or down radio station.
Using the Record Player (Phono Operation)
1) Open the dust cover and tap the POWER/VOLUME knob to turn the equipment on.
2) Use the function selector to select PHONO mode.
3) Set the speed selector to the appropriate position: 33, 45 or 78 RPM, depending on the record
to be played.
4) Set the auto stop control to ON if you want the turntable to stop when it reaches the end of the
record. If the switch is set to OFF, the turntable will continue turning at the end of the record.
5) Place the record on the turntable (use the 45 RPM adaptor, if required).
6) Move the lift lever towards the back to raise the tone arm from the arm park, then slowly move
the arm to the record. The turntable will start rotating.
7) Move the lift lever forward, the tone arm will gently drop onto the record and playback will
start.
8) To stop playback, move the lift lever back to raise the tone arm. The turntable will still be
rotating but the record will stop playing.
continuously for 3 seconds will automatically search and save radio
-9-
or skip down
or skip down button to select the
button to