Idiomas disponibles
Idiomas disponibles
Playing a Record
Always wipe records with a good cloth to remove dust
and other particles before placing the stylus in the |
starting grooves.
Also confirm that no dust is clinging
to the stylus.
A dirty record and stylus can cause
unpleasant static during record play.
|
The CP-1055F is a fully automatic turntable.
However,
manual and auto-repeat operation are also possible.
Be
sure the unit has been set properly before beginning
|
record play. In particular, check the tracking force
setting and connections regu larly.
Now, slowly rotate the counterweight
in the direction
of the arrow (the scale ring will also rotate) until the
Fully Automatic : Operation
correct amount of tracking force for the cartridge in use is
1. Place a record on the turntable mat a and set the
applied
Speed Selector (22) to the correct speed for the record
about to be played. The speed switches between 33 and
45 each time the Speed Selector 22) is pressed and
the corresponding indicator lights.
2. Set the Record Size Selector 21) to the correct
setting for the record about to be played.
The record size setting switches between 30 cm
and 17 cm
each time the Record Size Selector
is pressed and the corresponding indicator lights.
3, Hess the Fieve
Button a - the turntable
\gecarcan|
will
automatically
move
over
to
tne
reco rd ae
Rrwrie
ied
Set Se
into the starting grooves and begin record ene
4. When
the end of the record
is reached, the tonearm
13] will automatically return to the arm rest [12) and
the turntable platter [3] will stop rotating.
5. To interrupt record play before the end is reached,
depress the Play/Reject Button
[16). The tonearm
After setting the appropriate amount of tracking force,
will immediately return to the arm
rest
and |
set the anti-skating knob
to the same value.
If this
the turntable platter!3]will stop rotating.
is forgotten, the stylus may skid over the surface of the
6. Do not touch or forcibly move the tonearm during
record during record play.
this time as it will damage the automatic mechanism.
Connections
Manual Operation
|
Fully automatic operation can only be used to play a
record from the beginning.
To begin record play from
another location, it is necessary to operate the CP-1055F
manually.
:
|
|
isee dere
:
|
Press the Cue Button [17| to the up position to raise the
.
a
tonearm
|13| off the arm rest.
Now move the tonearm
over the record until the stylus is directly over the
section to be played; the turntable will automatically
begin rotating.
Depress the Cue Button again to lower
the tonearm onto the record surface and begin record
play.
The tonearm will automatically return to the arm
rest when the end of the record is reached or the Play/
Reject Button [16 is depressed.
)
Connect the output cord from the CP-1055F to the
PHONO
terminals of your audio amplifier as shown
below.
Connect the power cord to the socket on the
rear panel of the amplifier or the wall socket.
Repeat Function
To operate the repeat function, simply depress the
Repeat Button [19). The REPEAT LED indicator will
light up and the record will be played again and again.
The repeat function is cancelled by depressing the
Play/Reject Button [16| to stop record play immediately,
or by depressing the Repeat Button
once more, in
which case the record will be played to its end.
In
either case, the REPEAT
LED indicator will turn off.
Do not reverse left and right output cords.
