Troy-Bilt 020241 Manual Del Operario página 8

Section 3: Assembly
2. Insert carriage bok through Heft side hoHe from outside
of unit and attach a phstic knob from inside of unit
(viewing from rear of uniO.Tighten by hand (Figure 2).
3. Insert"L" bok through hoHe on right side of handHe
(viewing from rear of unit) and attach plastic knob.
Tighten knob by hand (Figure 2).
4. Insert"U' bolt through hole iust above billboard on
right side of handle (viewing from rear of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 2).Tighten by hand.
Placeaccessory tray over holes on handle (viewing
from front of unit). Pushthe tree clips into the holes
until they sit fiat against the accessory tray (Figure 3).
* Refer to engine manual for oil and fuel fit[ information,
Damage to equipment resulting from failure to follow this
instruction will void warranty,
* Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break-in. Refer to
engine operator's manual for recommendations.
0