Idiomas disponibles
Idiomas disponibles
TO REMOVECABLES, REVERSE
ORDER -
1. BLACK cable first from chassis and
then from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
REPLACING
BA'I-r E RY
_WARNING:
Do
not
short
battery
ter-
minals
by allowing
a wrench
or any other
object to contact
both terminals
at the same
time.
Before
connecting
battery,
remove
metal bracelets,
wristwatch
bands, rings, etc.
Positive
terminal
must be connected
first to
prevent
sparking
from accidental
grounding.
1.
Lift hood to raised
position.
2.
Disconnect
BLACK
battery
cable
(A)
then
RED battery
cable
and carefully
remove
battery
from tractor.
Negative
(Black)
Cable
INTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring.
See electrical wiring
diagram in the Repair Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
Hood
\
\
Headliaht Wire
(SOhnector
Positive 4
(Red)
Cable
3.
Stand
in front of tractor.
Grasp
hood at
sides,tilttoward
engine and liftoffoftractor.
4.
When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
3. Install new battery with terminals in
same position as old battery.
4. First connect
RED battery cable (B) to
positive (+) battery terminal with hex bolt
and keps nutas shown. Tighten securely.
Slide terminal
cover (C) over terminal.
5. Connect B LACKgrounding
cableto nega-
tive (-) battery terminal with remaining
hex bolt and keps nut. Tighten securely.
6. Close hood.
TO REPLACE
HEADLIGHT
BULB
1.
Raise hood.
2.
Remove
bulb holder
from the hole in
the backside
of the grill.
3.
Replace
bulb in holder
and install
bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close hood.
ENGINE
Maintenance,
repair, or replacement
of
the emission control devices and systems,
which are being done at the customers
ex-
pense, may be performed by any non-road
engine repair establishment
or individual.
Warranty repairs must be performed
by an
authorized
engine manufacturer's
service
outlet.
TO ADJUSTTHROTTLECONTROL
CABLE
The throttle
control
has been preset
at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable.
If adjust-
ment is necessary,
proceed
as follows:
27
