Idiomas disponibles
Idiomas disponibles
1. Put the heater on a fl at surface. Plug the appliance to AC
220-240V 50-60Hz socket. Please verify the rated current of
the power socket whether it fi ts the requirements; otherwise,
replace the socket.
2. Press down the on/off main button in the back cover, you
will hear the sound "Di", the LED screen display "--"
3. Touch on the Standby button
fi nger.
4. Boost heating function: Touch on the button
boost eating function, the heater would keep heating in 12
hours without temp sensor control.
5. Timer button: Touch on the button
display will show 0h(timer cancel), 1h, 2h...9h, in a continuous
cycle. When the timer function is enabled, the display shows
the remaining time.
6. Temperature setting: Touch on the button
get temperature from 10ºC->15ºC->20ºC->23ºC->27ºC
->30ºC in a continuous cycle.
7. Power setting: Touch on the button
mode as below in a continuous cycle.
Mode
Working status
8. Brightness of screen
The default brightness is 100% when switch on. Touch on
the button
25%, and off display in a continuous cycle.
Note: If there are no operations in 1 minute when it is in
100% brightness, the brightness would turn to 50%
automatically to save energy.
www.britec.es
OPERATION
H0
Fan mode
to change the brightness from 100%, 50%,
15
t
to start the heater by your
to set the timer, the
to set the working
H1
Low heating
750W
to start the
to set the tar-
H2
High heating
1500W
