Before Starting; Tools And Additional Components; Mounting Diagram - Clarion EQS755 Manual De Instrucciones Y De Instalación

Before starting

Mounting precautions
The EQS755 can be mounted next to the source unit or under the dash using the
mounting brackets. The front panel controls should be easily accessible from the
driver's seat. In addition:
This unit requires additional mobile audio components for proper operation.
Ÿ
• Always use great care when attaching anything to a vehicle! Check clearances in front
of, behind, and on both sides of the planned installation before drilling any holes or
installing any screws.
Wiring precautions
Disconnect the ground (-) terminal on the vehicle's battery.
To prevent short circuits during installation, always disconnect the vehicle's
negative (-) battery lead before making any connections.
This unit is exclusively for vehicles with a negative ground, 12V battery system.
Ÿ
Ÿ A good chassis ground connection is critical to minimize resistance and avoid noise
problems. Use the shortest wire possible and securely connect it to the car chassis and
the source unit ground.
Ÿ When routing RCA cables, keep the cables away from the power cables and output
speaker wires.
If you are using a source unit without a remote turn-on lead, the EQS755 can be turned
Ÿ
on with a switched accessory lead. This accessory power source is located in the
factory harness at the back of the radio. This lead turns on and off with the ignition key.
Do not open the case. There are no user-serviceable parts inside. If you require
Ÿ
assistance, consult your Clarion dealer or an authorized Clarion service center.

Tools and additional components

You will need:
• A Phillips-head screwdriver when mounting the unit in the vehicle.
• A small flat-head screwdriver to adjust the AUX gain controls if you connect an MP3
player or video source.
• High-quality RCA input and output cables.
Extra cable can cause signal loss and act as an antenna for noise. Use only highquality
RCA cables that are no longer than necessary to make a direct connection with the source
unit and amplifiers.
EQS755
8
WARNING

Mounting diagram

EQS755
9