Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PW-150
PW-150
V5.1
V5.1
COMPONENTS AND RECOMMENDED LOCATIONS IN THE VEHICLE
(1) Electronic unit
(1) Control keyboard & internal microphone
(1) 150W loudspeaker
(2) External microphones
(2) Internal speakers
(1) Keyboard harness
(1) Power cable (battery)
(1) Fuse 25A
(2) Speaker extension cables
(1) Loudspeaker and auxiliary load harness
(1) Hand microphone (optional)
(1) Hand microphone holder (optional)
INSTALLATION AND ELECTRIC DIAGRAM
To install the equipment, see the wiring diagram shown further on.
Avoid leaving visible cables in the cabin to maintain the vehicle's aesthetics unaffected.
If there are any cables left disconnected, insulate them with tape; disconnected cables
making an undesired contact can cause a malfunction.
Electronic Unit
Place it on a hidden location for aesthetic purposes. Make sure that the location
allows some ventilation into the unit to avoid overheating.
Digital Keyboard
To facilitate the handling of the equipment, place the keyboard on a location within
the driver's reach, such as the console of the vehicle. Clean the surface where the
keyboard is to be sticked to ensure an adequate adherence. Remove the protective
liner from the adhesive pad in the back side and stick it to the surface.
To clean the keyboard, gently wipe it with a dry cloth. Do not use water or any solvent.
Loudspeaker
When selecting the location for the loudspeaker, keep in mind that this component is
weather resistant but it is not immersion-proof. The loudspeaker must be placed as far
as possible from the keyboard (where the internal microphone is) to prevent feedback.
Splice and tape the loudspeaker wires to the output wires (they have no polarity).
External Microphones
Two locations are recommended for installation, as explained on the next page.
Internal Speakers
Place them at opposing sides inside the vehicle to get a stereo sound. Locate the
speakers out of view without affecting the sound.
Hand microphone (optional)
Place the hand microphone holder within easy reach of both driver and passenger.
EXTERNAL MICROPHONES INSTALLATION INSTRUCTIONS
Shell
Microphone
Mounting
tape
INTERNAL SPEAKER
INTERNAL SPEAKER
Each microphone includes a shell to hold
it in place and protect it from outdoor.
Depending on the installation procedure,
it can be more convenient to assemble
microphone and shell either before or
after the wiring. For instance, if the wiring
requires to pull the cable through a narrow
space, it is recommended to assemble after
wiring.
EXTERNAL MIC
CONTROL KEYPAD
& INTERNAL MIC
150W
LOUDSPEAKER
ELECTRONIC UNIT
PW-150
EXTERNAL MIC
2
2
Tabla de contenido
