Zibro SRE 440 E Instrucciones De Uso página 92

In case of any
malfunctioning the
information display
will tell you what is the
matter.
4
80
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
1 Press the button
Within approximately one minute the flame will have extinguished.
2 Press the TIMER key
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function.
H
THE INFORMATION DISPLAY
The information display ¹ not only serves as an indicator of the (set) time and
temperature (Sections C, E, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE INFORMATION
e - 0 Temperature within the heater too high.
f - 0
Power interrupted.
e - 1
Faulty thermostat.
f - 1 Faulty burner thermistor.
e - 2
Starting problems.
e - 5 Tipping-over protection.
e - 6
Poor burning.
e - 7 Room temperature
above 32°C.
e - 8
Defective booster.
e - 9 Air filter dirty; or
Fuel pump dirty.
The heater has been in operation
continuously for a period of 69 hours
and has turned itself off automatically.
Out of fuel.
-- : --
+
Too little ventilation.
-- : --
+
e - 1 1 Too little ventilation.
+
Always contact your Zibro dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 69 hours continuous operation. The following will then appear
in the display:
the button (see Section D).
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code cl:05 running back to cl:01. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
. The information display will show the CLOCK signal.
, when you want to switch off the heater and ignite it
. If desired, you can switch the heater on again by pressing
WHAT TO DO
Cool-down and re-ignite.
Re-ignite the heater.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Re-ignite the heater.
Contact your dealer.
If necessary,
re-ignite the heater.
Contact your dealer.
Clean filter
Contact your dealer.
Switch the heater back on.
Refill removable tank.
Ventilate better.
Ventilate better.