Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART
TROUBLE
CAUSE
REMEDY
Semi-automatic • Crowdingtnmmer line
• Allow tip of line to do the cutting.
head stops
against material being
under
a load or
cut.
• Electricalfailure.
Contact your Sears Service Cir.
Thrown circuitbreaker
•
Check Breaker Box.
• Debris stopping head
• Remove debris.
• Check line routing.
does not turn
when switch is
_ressed.
Line does not
advance or
breaks while
cutting.
Line welds
!onto spool.
• Line improperly
routed in head.
• Line improporly
wound onto spool.
• Incorrectline size
• Not enough line
outsideof head.
• Dirt buildupon cover.
• Une size is incorrect.
Incorrectspool.
Line is being crowded
against material being
cut.
Line releases
• Line improperly
continuously,
routedin head.
• Spool damaged.
Line usage is
excessive.
Une pulls
back into
head.
• Line improperly
routedin head.
• Line size is incorrect.
• Crowdingline against
materialbeing cut.
• Spool teeth worn
or damaged.
• Too little line outside
of head.
• Line size incorrect.
• Rewind line tightly and evenly.
• Use only.065in,
diameterline.
• Pull4inches
ofline outside of
"
head.
• Clean coveg
i Use only .065 in. diameter line.
Replace with correct spool.
Cut with tip of line fully extended.
• Check line routing.
• Replace spool.
• Check line routing.
• Replace spool.
• Cut with tip of linefully extended.
• Replace Spool
• Remove cover and pull 4 inches
of line outside of head.
• Use only .065 in. diameter line.
10
