Idiomas disponibles
Idiomas disponibles
Unpacking 'four Beverage Center
1.
Remove all packaging material. This includes the foam and the adhesive tape
from aH outside and inside surfaces, as wdI as accessories
and racks Slide
out and remove the plastic or foam guard used to protect
the compressor from
shipping damage caused by vibration and shock,
2.
inspect and remove any remaining packaging, tape or printed materials
before powering on the beverage center.
3.
Check to be sure you have all accessories and parts listed in the Parts and
Features section.
Proper Air Circulation
To ensure that your beverage center works at the maximum efficiency
it was
designed for, you should install it in a location where there is proper air
circulation,
plumbing and electrical
connections.
The foiiowing
are recommended
clearances around the beverage
center:
Sides .................. 3/4 inches (I9 mm)
Top ......................2 inches (50 mm)
Back .................... 2 inches (50 mm)
Electrical Requirements
Make sure there is a suitable power outlet (115 volts, 15 amps) with
proper grounding to power the beverage center.
WARNING: NEVERout off the third grounding prong from the power cord
plug to accommodate a two prong outlet. Removal of the prong provides no
effective grounding for the appliance, which can result in serious iniury or death
from electrical shock
Installation
Your beverage
center
is designed for freestanding
installation only. it should not be
recessed or built-in
Place the beverage
center on a floor strong enough to support it fully
!oadea
When moving the _ew-_rage center
never tilt it b,, more than a 45 degrees angle.
This could damage the compressor and the sealed SVsTem.
If the beverage
center
has been fi_ted more than 45 degrees,
let it stand in an upright
position for at least ! hour prior to plugging it into the power source. This
will allow the refrigerant TOsettle and reduce the possibility of a malfunction in
the cooling system.
Plug the _everage
center
into an exclusive, properw installed grounded wall outlet.
Do not under any circumstances cut or remove the third lgrounding)
prong from
the power cord. See. the WARNING
_n E/ectrica
Reauirements on the r_revious
page. Any questions concerning power and ,or grounding should be directed
toward a certifJed electrician
or a Sears or omer aualified service dealer.
After plugging the appliance into a wall outlet, allow the unit To run for 2 -3
hours so mat The interior is sufficienfl',
coot before opening the door to D_ace
bottles into me comoarrmem,
Installation
Limitations
Do not install your r_everage center
in any location
not properly
insulated or heated.
such as in a garage. Your beverage
center
is not designed _o operate in temperature
settings below 5.5° Fahrenheit
Select a suitable location for the beverage
center
on a hard even surface away from
direct sunlight or heat sources such as radiators,
baseboard
heaters or cooking
appliances.
Handle
Installation
[]
[]
1. Set the attachment
snorts of the hand)e over the attachment
posts protruding
from
the door, To avoid turning unit over, attach handles with set screws facing uo Jfunll s
_urnea over to facilitate
attaching
handle so that screws wit nOTbe seer, ,¢ou must Wa_T
" hour before p_ugging unit into oower source.
2. Use a 3 mm hex ke'y ro securel ¢ hgnren me set screws in the handle affachment
shafts
to the attachment
posts of the door.
7
6/8/10
