Idiomas disponibles
Idiomas disponibles
Faults
The adjustment wheels for
adjusting the roller height are
difficult or impossible to turn.
10. Disposal
NOTE
The product must be properly disposed of at the end of its service life.
11. Additional Information
11.1.
Notice of liability
Theme
General
Misuse
Safety
Disclaimer
Possible cause
The adjustment wheels were not
equal (roller height left and right).
⇒ To protect the environment, components and packaging that are easy to dispose
of have been predominantly used.
⇒ The components of the slab roller can be sent to local waste disposal for recycling.
By doing this, you help with the recovery, recycling and reuse of raw materials.
⇒ When disposing of the slab roller, observe the country-specific laws, regulations
and standards.
Description
⇒ The slab roller is built according to the state of the art and recognised safety rules.
⇒ Proper operation according to the intended use reduces the risk to people to an
acceptable level according to the current state of the art.
⇒ In the event of incorrect use, dangers to people and property and damage to the
slab roller can arise.
⇒ Therefore, please note:
− Only use the slab roller if it is in perfect technical condition.
− Use the slab roller only as intended.
− Only use the slab roller in a safety and hazard-conscious manner.
− Immediately eliminate any defects or malfunctions that could impair safety.
⇒ Safety information cannot be construed against the manufacturer.
⇒ Even if all safety and warning instructions, warning signs and operating instructions
are followed, there is no guarantee that the slab roller will not cause injury or
damage.
⇒ The manufacturer accepts no liability whatsoever for personal injury, damage to
property and damage to the product, as well as consequential damage that occurs
or has occurred as a result of non-compliance with these operating instructions,
improper use of the product, repairs and any other actions by unqualified and
unauthorised specialists on the product.
32 / 118 - EN -
Operator Troubleshooting
Set the two adjustment wheels back
until a uniform roller height is
reached (the distance between the
roller and the work surface
increases). Then set the adjustment
wheels identically on both sides.
Note:
Adjust them on each side in
increments of no more than 0.4 cm
so that nothing jams.
