Idiomas disponibles
Idiomas disponibles
pinching and kickback. Large workpieces
tend to sag under their own weight. Supports must be
placed under the workpiece near the line of cut and
near the edge of the workpiece on both sides of the
wheel.
j)
Use extra caution when making a
"pocket cut" into existing walls or other
blind areas. The protruding wheel may cut gas or
water pipes, electrical wiring or objects that can cause
kickback.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
18
OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for the horizontal cutting or slitting
of mainly mineral material such as marble.
1. INSTALLING OR REMOVING DIAMOND
CUTTING BLADE (SEE FIG. A B.)
a. Inserting the Diamond Cutting Blade (Not
Supplied) (See Fig. A)
Firstly, place inner flange (14) onto motor spindle (15);
Secondly, place diamond cutting blade (7) onto inner flange;
And then place outer flange (9) onto diamond cutting blade;
Finally, use spanner (16) hold outer flange and use socket
spanner (17) screw blade securing screw(8) into motor
spindle.
Warning: Left-hand thread!
Before reassembly, remove the parts for cleaning.
b. Removing Diamond Cutting Blade (See
Fig. B)
Removing diamond cutting blade according to reverse
sequence of above instruction
2. ADJUSTING THE DEPTH OF CUT (SEE
FIG.C)
Loosen the wing bolt on the Depth Guide (4) and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
Raise: for greater cutting depths.
Lower: for smaller cutting depths.
Use a ruler, scale or something similar to adjust the required
depth.
Retighten the winged bolt.
Maintain a uniform feeding speed during the entire cutting
procedure. If a perfect cut is desired, the Diamond-Cutting
Blade must protrude 2mm out of the material.
3. BEVEL CUTTING (SEE FIG. D)
Loosen the wing bolt for cutting angle setting.
Pivot the machine sideways until the desired cutting angle
is set on scale.
Tighten the wing bolt for the cutting angle setting angle
(0
- 45
).
O
O
4. SWITCH ACTION (SEE FIG.E)
Caution: Before plugging in the tool, always check
to see that the switch trigger actuates properly .
EN
