Powersmart DB2501 Manual De Instrucciones página 15

If the guard is damaged, do not use the brush cutter until it is replaced.
NOTE: Install the protective guard before operating the machine. It cannot be removed or
disassembled.
Remove the battery pack.

Install the safety guard to the working head in the direction of arrow 1.

BLADE INSTALLATION
WARNING: Wear protective gloves when handling or performing maintenance on the
blade to avoid injury. The blade is sharp and can cut you even when it is not moving.
WARNING: Do not attempt to use any blades, washers, nuts, or fastening hardware other than
shown in the following illustrations. These parts must be provided by the manufacturer and
installed as shown below. Failure to use proper parts can cause the blade to fly off and seriously
hurt you or others.
Install the upper pressing plate into the motor shaft, the blade into the upper pressing plate, and the

lower pressing plate (convex surface upward) into the blade.
Insert the screwdriver into the positioning hole of the motor and the upper pressing plate.

Install the M10 lock nut into the motor shaft and tighten it counterclockwise.

Remove the screwdriver.

15
Lock with screws (M5*14).