Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTINGCHART
CAUSE
1. Rear _ lawn mower
PROBLEM
Loasofpower
Poorcut-
Jneven
housing or cutting blade
dragging in heavy grass.
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup of grass, leaves,
and trash under mower.
5. Too much oil in engine.
6. Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
1. Worn, bent or loose blade,
2. Bent engine crankshaft.
CORRECTION
1. Set to "Higher Cut"
position.
2. Set to "Higher Cut"
position.
3. Cleardreptace air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
Excessive
1. Replace blade. Tighten
vibration
blade bolt.
2. Contact a Sears or other
qualified service center.
Starter rope
1. Engine flywheel brake is on
hard to pull
when control bar is release¢
2, Bent engine crankshaft.
3. Blade adapter broken.
4. Blade dragging in grass.
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact a Sears or other
qualified service center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
Loss of drive
1. Drive wheels not turning
1. Adjust or replace drive
with drive control engaged,
control cable.
2. Belt not driving
2. Put belt on pulleys or
replace belts if broken.
Grass catcher
1, Cutting height too low.
1. Raise cutting height,
notfllllng (if so
2. Lift on blade worn off.
2. Replace blade.
equipped)
3. Catcher not venting air.
3. Clean grass catcher.
Hard to push
1, Raise cutting height.
1. Grass is too high or wheel
height is too low.
2, Rear of lawn mower
housing or cutting blade
dragging in grass.
3. Grass catcher too full.
4. Handle height position not
right for you.
2. Raise rear of lawn mower
housing one (1) setting
higher.
3. Empty grass catcher.
4. Adjust handle height to
suit.
17
