Idiomas disponibles
Idiomas disponibles
Thank you for purchasing Timer Box IV. The Timer box IV is a 1-channel light
timer to switch several inductive loads such as electromagnetic ballast. And with a
Variable 0-10V or PWM signal for dimmable light. You have several features like:
Temperature surveillance avoids from overheating, day counter, sunset/sunrise
etc.
EN
The warranty is only valid with a warranty card containing sales date and
stamp from the place of purchase. Or electronic registered warranty at http://g-
systems.eu/warranty. If this is not so, please return immediately to the sales
office!
1. Watch
2. Rotary encoder (push)
3. Power LED
4. Socket for light
1. Return
2. Start time
3. Day counter
4. 12h ON cycle
5. 18h ON cycle
6. User-definable ON cycle
7. 12-24h format
8. Minuets
9. ON state
10. °C - °F format
The Timer box IV has a conventional electric wire-box wall mounting lugs on
each corner accessible from the inside of the timer box. Install the temperature
sensor which comes with a 4m long cable at a point where you wish to undertake
the measurement. Ensure that this is not directly exposed to a heat source or
stream of light in order to obtain the best precise measurement of the ambient air
temperature.
Connect your Lamps to the Exits 1-12 (depending on the model). Connect
your heater to the heater socket. The heater is On when the lights are OFF and
inverse. (Power management).
You can connect your 0-10/PWM signal for dimmable Ballast's and LED's.
The connector is located inside the Timer box IV.
22
Timer box IV
Foreword
Warranty
Legend
5. Socket for heating
6. Temperature sensor
7. Exit 0-10V/PWM
8. Power cable
Legend watch segmetns
11. Manual infinitive setting
12. Temperature
13. Manual 1-cycle setting
14. Start light temperature
15. Stop light temperature
16. OFF state
17. Hours
18. ON time segment
19. Off time segment
20. Current time setting
Mounting installation
