Idiomas disponibles
Idiomas disponibles
Assembly Instructions
4. Connect the Low-Pro's (A) top outlet port to your
vacuum with Hose (D) and Elbow (E) as shown
in [FIG. 3].
Connect the Low-Pro's side inlet port to your
tool with your vacuum's hose [FIG. 3].
Note: Both ports accept standard 2.5" hose cuffs
(OD ≈ 2.25").
D
To vacuum
5. Review [FIG. 4] for common air leak points.
Note: Any air leak will affect separation
performance. Make sure to check your dust drum
frequently so you do not overfill it.
Leak Point
(Outlet)
To Tool
E
FIG. 3
Leak Point
(Inlet)
Leak Point
(Low-Pro/
bucket)
FIG. 4
Optional Grounding Instructions
Recommended for fine dust situations or
Ÿ
electronically sensitive applications.
6. Install the Metal Tape (F) to the Lid Separator (A)
so that the inlet, outlet, and flange are attached by
a continuous, conductive path as shown in [FIG
5a]. The Metal Tape should wrap 1/4" around the
edge of each opening.
Note: For added grounding, attach a self-
supplied wire with a ring terminal on one
end and a washer tied to the other end when
installing one of the latches in step 2. The wire
must be long enough for the washer to lie on the
floor [FIG 5b].
F
Wire
Washer
FIG. 5a
FIG. 5b
oneida-air.com
