Idiomas disponibles
Idiomas disponibles
HOW TO SET UP YOUR UNiT
iMPROPER GROUNDING
CAN RESULT iN ELEC=
Location
of the Air Compressor
TRICAL SHOCK.
Locate the air compressor
in a clean, dry and well
ventilated area. The air compressor should be located
at least 12" away from the wall or other obstructions
that will interfere with the flow of air. The air compres-
sor pump and shroud are designed to allow for proper
cooling. The ventilation openings on the compressor
are necessary to maintain proper operating tempera-
ture. Do not place rags or other containers on or near
these openings.The
air filter must be kept clear of
obstructions
which could reduce air flow to the air
compressor.
GROUNDING
iNSTRUCTiONS
RISK OF ELECTRICAL
SHOCK.
In the event of a
short circuit, grounding reduces the risk of
shock by providing an escape wire for the
electric current. This air compressor
must be
properly grounded.
The portable air compressor is equipped with a cord
having a grounding wire with an appropriate ground-
ing plug (see following illustrations).
The plug must be
used with an outlet that has been installed and
grounded in accordance with all local codes and ordi-
nances.
1.
The cord set and plug with this unit contains a
grounding pin. This plug MUST be used with a
grounded outlet.
iMPORTANT: The outlet being used must be installed
and grounded in accordance with all local codes and
ordinances.
2.
Make sure the outlet being used has the same
configuration
as the grounded plug. DO NOT USE
AN ADAPTER. See illustration.
Grounding
Pin
_Grounded
/
Outlets
.
.
Inspect the plug and cord before each use. Do
not use if there are signs of damage.
If these grounding instructions are not completely
understood,
or if in doubt as to whether the com-
pressor is properly grounded,
have the installation
checked by a qualified electrician.
Do not modify the plug provided,
if it does
not fit the available
outlet, a correct
outlet
should
be installed by a qualified
electri-
cian.
Repairs to the cord set or plug MUST be
made by a qualified
electrician.
Extension
Cords
Use extra air hose instead of an extension cord to
avoid voltage drop and power loss to the motor, and
to prevent overheating.
If an extension cord must be used, be sure it is:
•
a 3-wire extension cord that has a 3-blade
grounding plug, and a 3-slot receptacle that will
accept the plug on the product
in good condition
no longer than 50 feet
12 gauge (AWG) or larger. (Wire size increases as
gauge number decreases.
10 AWG and 8 AWG
may also be used. DO NOT USE 14 OR 16
AWG.)
Voltage
and Circuit
Protection
Refer to the Parts Manual for the voltage and mini-
mum branch circuit requirements.
Certain air compressors
can be operated on a 15 amp
circuit if the following conditions are met.
1.
Voltage supply through branch circuit is 15 amps.
2.
Circuit is not used to supply any other electrical
needs (lights, appliances, etc.).
3.
Extension cords comply with specifications.
4.
Circuit is equipped with a 15 amp circuit breaker
or 15 amp time delay fuse. NOTE: If compressor
is connected
to a circuit protected by fuses, use
only time delay fuses. Time delay fuses should be
marked "D" in Canada and "T" in the US.
If any of the above conditions
cannot be met, or if
operation of the compressor
repeatedly causes inter-
ruption of the power, it may be necessary to operate it
from a 20 amp circuit. It is not necessary to change
the cord set.
9- ENG
D23358
