Idiomas disponibles
Idiomas disponibles
ALL o
TT
Before Putting Into Use
* Before connecting the appliance to electrical power — * If the gasket is damaged or the door seal is
supply, leave it stand for about 2 hours, which will
poor, energy consumption is substantially
reduce the possibility of malfunctions in the cooting
higher. To restore efficiency, replace
system due to transport handling.
the gasket.
* Clean the appliance thoroughly, especially in the
* Always consider instructions stated in
interior (See Cleaning and Maintenance).
sections Positioning and Energy Saving
+ In case the interior accessories are not correctly
Tips, otherwise the energy consumption is
placed, rearrange them as described in chapter
substantially higher.
"Description of the Appliance".
Instructions for Use
These instructions for use are intended for the user.
They describe the appliance and correct operating
procedures for safe use.
SAVE THESE INSTRUCTIONS:
| We Care for the Environment |
* Our products use environmentally friendly manner.
To this end, individual packaging materials are
clearly marked.
:
* These instructions are printed either on recycled
paper or chlorine free bleached paper.
* When your appliance finally wears out, please try
not to burden the environment with it; call your
nearest authorized service agent. (See Disposing
of Worn Out Appliance)
¡ Tips for Energy Savings
3
* Try not to open the door too often, especially when
the weather is hot and humid. Once you open the
door, close it as soon as possible. This is especially
important if you have an upright model.
Every now and then check if the appliance is
sufficiently ventilated (adequate air circulation
behind the appliance).
Set the thermostat from higher to lower settings as
soon as possible (depends on how loaded the
appliance is, ambient temperatures etc).
Before loading the appliance with packages of fresh
foods, make sure that they are cooled to
ambient temperature. (excluding soups)
Ice and frost layers increase energy consumption,
so clean the, appliance as soon as the frost layer
is 3-5 mm thick.
Tt
