Kesser Premium Manual De Instrucciones página 32

Operation
Plug the power cord into a 220-240 Volt 15 Amp outlet.Make sure the outlet is in
good condition and that the plug is not loose.NEVER exceed the maximum
amperage for the circuit.DO NOT plug other appliances into the same circuit.
Cleaning:
Turn heater OFF and unplug from electrical outlet before any cleaning or

maintenance is performed. Wait at least 10 minutes to allow all components to
cool properly.
Use a vacuum or duster to keep heater and vent area clean from dust and dirt.

The exterior of the fireplace should be cleaned with a damp cloth or duster.

Do not use abrasive cleaners or liquid sprays.
WARNINGS AND CAUTIONS
WARNING To avoid electrical shock not open the back panel of the insert unless
the Power has been turned off. And the insert has been unplugged.
WARNING Any electrical repairs.to this electric fireplace. Should only be
Performed by a qualified technician.
WARNING Any electrical wiring repairs should only be performed by a qualified
Technician. And also must
comply with local buildings codes.
WARNING Discontinue use of this electric fireplace if any of the follow has
Occurred: Water damage. If insert
has been or dented. If power cord has Become broken. If power
cord becomes hot to touch, if unit smokes or Smells like smoke.
Note: When the heat functions is used for the first time. A slight odor may be
Present. This is normal and should
be occur again unless heater is not used For extended periods of time
and dust is allowed to accumulate on heater Element.
Technical Specification
Supply: 220-240V 50-60Hz

Rated power:900W/1800W

Safety Cut-Off
This appliance is fitted with a safety cut-off which will operate if the fire overheats

(e.g. due to blocked air vents) .For safety reasons, the fire will NOT automatically
reset.
To reset the appliance, disconnect the appliance from the mains supply for at

Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
32
www.eshopping.de