Idiomas disponibles
Idiomas disponibles
Usethisreceptacle to operate 2 40 Volt A C,60Hz, s ingle
phase l oads requiring u pto 8,000 watts(8.0 kW)ofpower.
Theoutlet i s protected b ya35Amppush-to-reset circuit
breaker.
120/240 Volt AC, 30 Amp,
Locking
Receptacle
Use a N EMA LI4-30 plug with this receptacle. Connect a
4-wire cord set rated for 250 Volt AC loads at 30 Amps (or
greater) (Figure 6).You can use the same 4-wire cord if you
)lan to run a 120Volt load.
4-Wire Cord Set
i
f
(Neutral)
Y (Hot)
|
X (Hot)
NEMA L 14-30
/_
Ground
(Green)
This
receptacle
powers 1201240 Volt AC, 60 Hz, single
phase loads requiring
up to 3,600
watts
of power
at
30 Amps for 120Volts;7,200 watts of power (7.2 kW) at
30 Amps for 240Volts.The outlet is protected by a 30 Amp
push-to-reset
circuit
breaker.
120 Volt AC, 30 Amp
Locking
Receptacle
Use a NEMA L5-30 plug with this receptacle. Connect a
3-wire cord set rated for 125Volt AC loads at 30 Amps to
the plug (Figure 7).
_ire
Cord Set
NEMA
L5-30
Neutral
120V
Hot
Ground (Green)
Use this receptacle to operate 120Volt AC, 60 Hz, single
phase loads requiring up to 3,600 watts (3.6 kW) of power
at 30 Amps.The outlet is protected by a 30 Amp
push-to-reset circuit breaker.
120 Volt AC, 20 Amp,
Duplex
Receptacle
Each receptacle (Figure 8) is protected against overload by
a 20 Amp push-to-reset circuit breaker.
Use each receptacle to operate 120Volt AC, single-phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW)
at 20Amps of current. Use cord sets that are rated for
125Volt AC loads at 20 Amps (or greater).
i
10
