Idiomas disponibles
Idiomas disponibles
,_
WARNING:
To prevent accidental starting that could cause serious personal injury,
always disconnect the sander from the power source when assembling parts, making
adjustments, installing or removing sandpaper, cleaning, or when it is not in use.
TURNING
THE SANDER
ON/
OFF (Fig. 2}
1.
Plug the sander into
a power source.
2.
To turn the sander on,
depress the ON switch.
3.
To turn the sander off,
depress the OFF switch.
LED WORKLIGHT
(Fig. 3)
The LED worklight,
located
on the front of the sander will
turn on when the ON switch
is
depressed.
The LED worklight
will
turn off when the OFF switch is
depressed.
The worklight
provides
additional
lighting on the surface
of the workpiece
for operation
in
lower-light
situations.
,_
WARNING:
The worklight
aids
in illuminating
the sanding area.
It is not a substitute
for adequate
work area lighting.
Failure to obey
this warning could cause serious
personal injury.
ATTACHING
THE
SANDPAPER
(Fig. 4)
1.
Disconnect
the detail sander
from the power source.
2.
Remove any dust or debris
from the base plate.
3.
Align the sandpaper
holes
with the holes on the base
plate and press it firmly in
place to ensure a good attachment.
Fig. 2
Fig. 3
LED worklight
Fig. 4
Sandpaper
Base plate
11
