Idiomas disponibles
Idiomas disponibles
Troubleshooting- ElectronicIgnition
SECTIONI
Nosparksappearat
anyelectrodes when
controlknobturnedto
; no noisecanbe
heardfromspark
module.
• Batterynotinstalled
properly.
• Dead battery.
• Buttonassembly not
installedproperly.
• Faulty spark module.
• Check battery orientation.
• Has battery been used
previously?
• Checkto insurethreads are
properlyengaged.Button
shouldtravel upand down
withoutbinding.
• If no sparksare generated
with newbatteryandgoodwire
connections, moduleisfaulty.
• Install battery (make sure that "+" and "-"
connectors are oriented correctly, with "+" end up
and "-" end down.)
• Replace battery with new AAA-size alkaline battery.
• Unscrew buttoncapassembly and reinstall,making
surethreadsare alignedandengaged fully.
• Replace spark module assembly.
SECTION II
• Output lead connections
• Are output connections
• Remove and reconnect all output connections at
No sparks appear at
not connected,
on and tight?
module and electrodes.
any electrodes when
control knob turned to
• noise can be
heard from spark
module.
• Outputleadconnections
notconnected.
• Electrical arc between
output wires and grill
frame.
• Weak battery.
• Electrodes are wet.
• Electrodes crackedor
Broken; " sparksat crack"
SECTION III
Sparks are present
but not at all
electrodes and/or not
at full strength
• Are output connections on
and tight?
• If possible, observe grill in
Dark location.Operate ignition
system and look for arcing
between output wires and grill
frame.
• All sparks present but weak
or at slow rate.
• Has moisture accumulated
on electrode and/or in burner
ports?
• Inspect electrodes for cracks.
• Remove and reconnect all output connections at
module and electrodes.
• If sparks are observed other than from burner(s),
wire insulation may be damaged. Replacewires.
• Replace battery with a new AAA-size alkaline
battery.
• Use paper towel to remove moisture.
• Replace cracked or broken electrodes.
146.23770310 • 25
