Venicci ENGO BASE Manual Del Usuario página 10

Installation in the vehicle
4.2 Installation instructions for 40-87 cm, Rearward facing,
ISOFIX + Support Leg + harness.
4.2.1 Method one:
First install the base on the seat, then put the infant carrier into the base.
Caution: Please only move to next step when ISOFIX has been slid to the
end with appearing the red marks.
15
Unfold support leg until it locks in place.
Press the ISOFIX release button to slide
the ISOFIX connectors to the end.
Push the ISOFIX connectors directly into the an-
chorages until you hear and audible sound "click" .
Grasp the seat base to check the seat if it is fastened
tighly or shakes, meanwhile observe the ISOFIX red/
green indicator. If the seat shakes and the ISOFIX
connectors are pulled out, please repeat the above
steps and install it again.
Squeeze the support leg
adjusting button, pull out the
support leg until it rests firmly
on the floor. Observe the ISOFIX
red/green indicator ro confirm
the installation status.
Installation in the vehicle
Pull the infant carrier into the base, and ensure that the handle is in its upper position D.
4.2.2 Method two:
First install infant carrier into the base, and then install both on the seat.
Put the infant
carrier into the
base.
Unfold support
leg until it locks
in place. Press the
ISOFIX release
button to slide the
ISOFIX connectors
to the end.
Push the ISOFIX connectors directly into the
anchorages until you hear an audible sound "click" .
Grasp the seat base to check the seat if it is fastened
tighly or shakes, meanwhile observe the ISOFIX red/
green indicator. If the seat shakes and the ISOFIX
connectors are pulled out, please repeat the above
steps and install again.
Squeeze the support leg
adjusting button, pull out
the support leg until it rests
firmly on the floor. Observe the
ISOFIX red/green indicator to
confirm the installlation status.
16