Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway.
Make sure
tires are properly inflated (See "PROD-
UCT SPECIFICATIONS"
section of this
manual).
If tires are over or underinflated,
you will not properly adjust your mower.
SIDE-TO-SIDE
ADJUSTMENT
• Raise mower to its highest position.
• At the midpoint of both sides of mower,
measure height from bottom edge of
mower to ground.
Distance '_' on both
sides of mower should be the same or
within 1/4" of each other.
• If adjustment
is necessary,
make adjust-
ment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment
nut on that side.
• To lower one side of mower, loosen lift
link adjustment
nut on that side.
NOTE:
Each full turn of adjustment
nut
will change mower height about 1/8".
• Recheck measurements
after adjusting.
Bottom edge
Bottom edge of
mower to ground
• To lower front of mower loosen nut "E" on
both front links an equal number of turns.
• When distance "D" is 1/8" to 1/2"
lower at front than rear, tighten nuts "F"
against trunnion on both front links.
• To raise front of mower, loosen nut "F"
from trunnion on both front links. Tighten
nut "E" on both front links an equal num-
ber of turns. The two front links must
remain equal in length.
• When distance "D" is 1/8" to 1/2" lower
at front than rear, tighten nut "F" against
trunnion on both front links.
Recheck side-to-side
adjustment.
Both Front Links Should be Equal in Length
n Arm
Lift Link
Adjustment
Nut
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck must be level side-to
side. If the following front-to-back
adjust-
ment is necessary, be sure to adjust both
front links equally so mower will stay level
side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so
that the front is approximately
1/8" to 1/2"
lower than the rear when the mower is in
its highest position.
Check adjustment
on right side of trac-
tor. Measure distance "D" directly in front
and behind the mandrel at bottom edge of
mower housing as shown.
• Before making any necessary adjust-
ments, check that both front links are
equal in length.
• If links are not equal in length, adjust
one link to same length as other link.
Front Links
TO REPLACE
MOWER
BLADE
DRIVE
BELT
The mower
blade
drive belt may be re-
placed
without
tools.
Park the tractor
on
level surface.
Engage
parking
brake.
BELT REMOVAL
-
1. Remove mower from tractor (See "TO
REMOVE
MOWER" in this section of
manual).
2. Work belt off both mandrel pulleys and
idler pulleys.
3. Pull belt away from mower.
BELT INSTALLATION
-
1. Work belt around both mandrel pulleys
and idler pulleys
2. Make sure belt is in all pulley grooves
and inside all belt guides.
24
