Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FIREPLACE & NONCOMBUSTIBLE BOARD
1.
Insert fireplace into enclosure.
2.
Level fireplace.
3.
Secure three middle mounting brackets with drywall screws
to the framed opening above the fireplace as shown in
Figure 43.
Notice: The drywall screws are located in the instruction
envelope packet. Secure fireplace on left and right through
side nailing flanges.
4.
Install the fireplace cabinet face flush with the wall-board,
secure the nailing flanges at the top and sides of the
fireplace with a 1/2-inch setback. This allows you to use the
supplied non-combustible board above the fireplace.
5.
Check gas lines for leaks.
6
Plug AC adapter and LED transformer to junction box.
7.
Install the wall-mounted control box within 10 feet of the
center of the fireplace.
(See Figure 43)
R
C E N T E
O F
A C E
F IR E P L
8.
Install a plastic bushing in both the liner and outer walls of
the fireplace. (See Figure 44 & 45)
Page 28
INSTALLATION - FLUSH MOUNT
SCREW INTO
EACH BRACKET
T
1 0 F E E
M A X
6 " M IN
WALL MOUNT
CONTROL BOX
Figure 43
Figure 44
9.
Route the yellow LED wire harness, grey remote receiver
harness,and red/black battery backup harness through the
bushings to the wall mount controls and connect.
(See Figure 46)
COVER PLATE
10. Set receiver in wall box to remote. Set switch on side of heat
shield to intermediate pilot (up).
*If switch is in "standing pilot" (down position, the pilot will ignite
automatically when power to the fireplace is turned on .
Figure 45
REMOTE
SWITCH
GRAY EXTENSION
WIRE
TO FIREPLACE
YELLOW EXTENSION
WIRE
TO FIREPLACE
Figure 46
36776-4-0117
Tabla de contenido
