6.
With
a level,
check
the dryer,
and make
necessary
adjustments
to the leveling
legs.
7.
At this time, make sure all gas connections
(on gas models),
exhaust
and electrical
connections
are complete.
Plug dryer in, and check operation
by using the check
list below.
8.
(GAS MODELS
ONLY)
The burner may not ignite initially due to air in the gas line.
Allowing
the dryer to operate
on a
heat setting
will purge the line.
If the gas does not ignite within five minutes,
turn the dryer off
and wait
5 minutes.
Be sure the gas supply to the dryer has been turned
on.
In order to confirm
gas
ignition,
check the exhaust
for heat.
FINAL
INSTALLATION
CHECK
LIST
Dryer is plugged
into electrical
outlet and is properly
grounded.
Exhaust
duct work is hooked
up and joints taped.
Plastic
flexible duct is NOT used.
Use rigid or stiff walled
flexible
metal vent material.
Dryer is level with all legs firmly on the floor.
Gas Models - gas is turned on, there are no gas leaks.
Start dryer to confirm
dryer runs, heats,
shuts off.
Demonstrate
use to consumer.
HOUSEHOLD
INSTALLATION
ACCESSORIES
• Vent hood - 4" (10.16 cm) opening
- 059129
• Aluminum
pipe - 4" x 24" (10.16 cm x 60.96 cm) - 059130
• Aluminum
elbow - 4" (10.16 cm) - 059131
• Aluminum
window
plate - 15" x 20" (38.10 cm x 50.80 cm) - 4" (10.16 cm) hole - 059134
• Flexible
aluminum
vent duct - 4" (10.16 cm) diameter
- 38" (81.28 cm) length stretches
to 8'
(2.44 cm) - 304353
Clamp for flexible
aluminum
duct - 304630
Exhaust
duct kit for base or left side exhausting
- 12002641
Rectangular
vent kit - 059144
Dacron
lint bag - 311353
NATURAL
to LP conversion
kit - 306195
LP to NATURAL
conversion
kit - 306204
Anchor
bracket
kit - 12002643
Grounding
kit-
12001875
Power cords - 240 v, 30 A
4_
5'
6'
10'
4'
5'
6'
10'
121.9 cm) - 3-wire - 33001780
152.4 cm) - 3-wire - 33001822
182.9 cm) - 3-wire - 33001823
304.8 cm) - 3-wire - 33001838
121.9 cm) - 4-wire - 33001781
152.4 cm) - 4-wire - 33001824
182.9 cm) - 4-wire - 33001825
304.8 cm) - 4-wire - 33001838
11