Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing wiring harness
5. Locate a suitable grounding point near the black box such as an
existing ground stud or drill a 3/32" hole and secure the white
wire using the eyelet and screw provided. (Do not drill into vehicle
floor or bed.) Clean dirt and rustproofing from area.
Verify what is behind any surface prior to drilling to avoid damage to
the vehicle and/or personal injury. Do not drill into any exposed
surfaces.
6. Route harness containing the green wire to the passenger side.
Route wire across the threshold and behind the passenger's side
felt panel to the taillight pocket.
©2023 Horizon Global™ Corp
Installation Instructions
PART NUMBER: 118884
7. On the passenger's side taillight pocket. Locate the connector
8. Disconnect the vehicle's Negative (-) battery cable. If not removed,
matching the end of the T-One ® Connector. Insert the T-One ®
Connector end containing the green wire in between the vehicle
and taillight connectors. All connector's surfaces should be clean
and free of dirt. Be careful not to break any locking tabs.
remove the fuse from the yellow fuse holder (provided).
Sheet 4 of 18
118884-NP
3/24/2023
Rev. X1
