Muse M-1028 CVB Manual De Instrucciones página 22

Idiomas disponibles

Mounting in the Vehicle

Use the supplied car mounting brackets to install units on the back of the vehicle's

headrests.

1. Remove the 4 screws on the headrest bracket. Fix the headrest bracket into the steel

pipes of the vehicle's headrest using these screws.

2. Fix the back holder and connecting shaft through the joint rotation fastening knob.

3. Combine the holder into the headrest bracket.

4. Fix the unit to the back holder using the knob screws.

DVP-5175 IB MUSE 001 REV3.indd 22

GB - 19

Caution!

- Make sure the screws are properly locked to avoid accidental loosening.

- Always remember to lock the holder to ensure the safety of your passengers.

- Do not install when car travels.

5. Connect the 12V car plug as shown.

CAUTION: Using other car plugs could damage the unit.

SAFETY WARNING!

• On no account should this unit be used by the driver of a moving motor vehicle, or left

unsecured in the vehicle whilst driving.

• If this unit is being used by a passenger in your vehicle, be sure that it is secured or held

safely, and does not obstruct any safety device (i.e. airbag, seat belt etc.) that is fitted.

• All passengers should wear seat belts when using this unit in a moving vehicle.

• If in doubt, please contact your vehicle manufacturer for further advice.

• Using other car power adaptors could damage the unit.

GB - 20

2023/6/28 17:19:26