Idiomas disponibles
Idiomas disponibles
The operation
of any tractor
can
result in foreign
objects
thrown
into the eyes,
which can result in severe eyedamage.
Always wear safety glasses or eye shields
while operatingyour
tractor or performing
any adjustments
or repairs.
We recom-
mend standard
safety glasses
orawidevision
safety maskworn
over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt bythe operator to leave
the seat without first setting the parking brake
will shut off the engine,
1. Depress brake pedal (B) allthe way down
and hold.
2. Pull parking brake lever (C) up and hold,
release pressure from brake pedal (B),
then release parking brake lever. Pedal
should remain in brake position. Ensure
parking brake will hold tractor secure.
STOPPING
MOWER BLADES -
• To stop mower blades, move attachment
clutch controlto disengaged position (r_l).
• Turn ignition key (F) to "STOP" position
and remove key. Always remove key when
leavingtractor to prevent unauthorized use.
• Never use choke to stop engine.
IMPORTANT: Leaving the ignitionswitch in
any position other than "STOP" wilt cause the
battery to discharge and go dead.
NOTE: Under certain conditions when tractor
is standing idle with the engine running, hot
engine exhaust gases may cause "brown-
ing" of grass, To eliminate this possibility,
always stop engine when stopping tractor
on grass areas.
_1,CAUTION: Always stop tractor com-
pletely, as described above, before leaving
the operator's position.
TO USE THROTTLE CONTROL
Always operate engine at full speed (fast).
• Operating engine at less than full speed
(fast) reduces engine's operating
effi-
ciency,
• Full speed (fast) offers the best mower
performance,
(_1_) Attachment
(t_)
Attachment
TO MOVE FORWARD AND BACKWARD
.......... ,,Olutct_ £ontr£!.....................
OlutphOpntr?,! ............ ]'he direction and speed of movement ..............
Lngagea
LJisengagea
'
is controlled by the forward and reverse
GROUND DRIVE-
- Tostop ground drive, depress brake pedal
all the way down.
IMPORTANT: Forward and reverse drive
pedals return to neutral position when not
depressed.
ENGINE -
, Move throttle control (D) between half and
full speed (.fast)position.
NOTE: Failure to move throttle control be-
tween half and full speed (fast) position, be-
fore stopping, may cause engineto"backfire".
drive pedals.
I, Start tractor and release parking brake.
2. Slowly depress forward (K) or reverse (L)
drive pedal to begin movement, Ground
speed increases the further down the
pedal is depressed,
1I
