Tabla de contenido
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
_,WARNING:
Do not short battery
terminals
by allowing
a wrench
or any
other
object
to contact
both terminals
at
the same
time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings,
etc.
Positive
terminal
must be connected
first to prevent
sparking
from accidental
grounding.
1.
Lift seat pan to raised
position.
2.
Disconnect
BLACK
battery
cable
first
then
RED battery
cable
and carefully
remove
battery
from tractor.
3.
Install
new battery
with terminals
in
same
position
as old battery.
4.
First connect
RED battery
cable
to
positive
(+) terminal
with hex bolt and
keps nut as shown.
Tighten
securely.
Slide terminal
cover
over terminal
5.
Connect
BLACK
grounding
cable to
negative
(-) terminal
with remaining
hex bolt and keps nut. Tighten
securely.
Seat
Terminal
Keps
Nut
Hex
Bolt
Positive (Red) Cable
Negative (Black) Cable
TO REPLACE
HEADLIGHT
BULB
1.
Raise
hood.
2.
Pull bulb holder
out of the hole in the
backside
of the grill.
3.
Replace
bulb in holder
and push
bulb
holder
securely
back into the hole in
the backside
of the grill.
4.
Close
hood.
INTERLOCKS
AND
RELAYS
Loose
or damaged
wiring
may cause
your tractor
to run poorly,
stop running,
or
prevent
it from starting.
• Check
wiring.
See electrical
wiring
diagram
in the Repair
Parts section.
TO REPLACE
FUSE
Replace
with 20 amp automotive-type
plug-in
fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD AND GRILL AS=
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor.
Grasp hood at
sides tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
ENGINE
Maintenance,
repair, or replacement
of the
emission
control devices
and systems,
which
are being done at the customers
expense,
may be performed
by any non-road
engine
repair establishment
or individual.
Warranty
repairs
must be performed
by an authorized
engine manufacturer's
service outlet.
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle
control
has been
preset
at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable.
If adjust-
ment is necessary,
proceed
as follows:
1. With engine
not running,
move throttle
control
lever from
slow to choke
posi-
tion.
Slowly
move
lever from choke
to
fast position.
2.
Check
that holes
'_'
in governor
control
lever and hole in governor
plate
line-up.
If holes
'_' are not aligned,
loosen
clamp
screw
and move throttle
cable
until
holes
are aligned.
Tighten
clamp
screw
securely.
Governor Control Lever
Governor Control Plate
Holes
"A"
Clamp Screw
Cable
27
Tabla de contenido
