Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
_WARNING:
Do not short batteryterminals
by allowing a wrench or any other object to
contact both terminals
at the same time.
Before connecting
battery, remove metal
bracelets,
wristwatch
bands,
rings,
etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.
1. Lift hood to raised position.
2. DisconnectBLACKbatterycabte
(A)then
RED battery cable and carefully remove
battery from tractor.
3. Install new batterywith terminals in same
position as old battery.
4. First connect RED battery cable (B) to
positive (+) batteryterminal
with hex bolt
and keps nut as shown. Tighten securely.
Slide terminal cover (C) over terminal.
5. Connect BLACK grounding cable to neg-
ative (-) battery terminal with remaining
hex bolt and keps nut. Tighten securely.
6.
Close hood.
_
Negative
(Black)
_.-;_
-
Cable
CableCable
_"__"i' " " ,
TO REPLACE
HEADLIGHT
BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in the
backside of the grill.
4. Close hood.
iNTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
• Check wiring.
TO REPLACE
FUSE
Replace with 30 amp automotive-type
plug-
in fuse. The fuse holder is located behind
the dash.
TO
REMOVE
SEMBLY
1.
2.
3.
4.
HOOD AND
GRILL AS=
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
When replacing hood, be sure to recon-
nect the headlight wire connector.
Hood
Headlight Wire
\
Connector
\\
\
TRANSMISSION
REMOVAL/REPLACEMENT
Should your transmission require removal for
service or replacement, it should be purged
after reinstallation and before operating the
tractor. See "PURGE TRANSMISSION"
in
the Operation section of this manual.
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle
control
has been preset at
the factory and adjustment
should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke
control
has been preset
at
the factory and adjustment
should not be
necessary. If adjustment
is necessary, see
engine manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atthe factory
and adjustment should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. If the engine does
need adjustment, see engine manual.
30
