Idiomas disponibles
Idiomas disponibles
Your new tractor has been assembled at the factory with exception of those parts left
unassembted for shipping purposes.
To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely.
Use the correct tools
as necessary to insure proper tightness.
TOOLS
REQUIRED
FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(2) 7/16" wrenches
Utility knife
(1) 1/2" wrench
Tire pressure gauge
(1) 3/4" wrench
Pliers
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench
Flashlight
ADJUST SEAT
1. Sit in seat.
2. Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press clutch/brake
pedal all the way down.
3. Release lever to lock seat in position.
When right or left hand is mentioned in this
manual, itmeanswhen you areinthe operating
position (seated behind the steering wheel).
TO
REMOVE
TRACTOR
FROM
CARTON
UNPACK CARTON
*
Remove all accessible loose parts and
parts cartons from carton.
*
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
*
Remove mower and packing materials.
*
Check for any additional loose parts or
cartons and remove.
BEFORE
REMOVING
TRACTOR
FROM
SKID
TO CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance
section of this
manual for charging instructions).
*
Forbatteryand batterycabteinstatlationsee
"REPLACING BATTERY" inthe "Service
and Adjustments" section in this manual.
-.>_
Label
NOTE: You may now roll your tractor off the
skid. Follow the instructions below to remove
the tractor from the skid.
_i_ WARNING:
Before starting,
read, un-
derstand and follow all instructions
in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR
OFF SKID
(See
Operation
section
for
location
and
function
of controls)
1. Raise attachment
lift lever to its highest
position.
2. Release
parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral position.
4. Roll tractor forward off skid.
Continue with the instructions that follow.
TO INSTALL
MOWER
1. SET PARKING
BRAKE LEVER AND
LOWER ATTACHMENT LIFT LEVER
Depress clutch/brake
pedal all the way
down and hold.
Pull parking brake lever up and hold,
release pressure from clutch/brake pedal,
then release parking brake lever. Pedal
should remain in brake position. Ensure
parking brake wilt hold tractor secure.
Brake Lever
8
